Products | Piletips
VS-300N Series H-Pile Points
Versa-Steel H-Pile points are made of high strength, low alloy cast steel. Cast steel is a superior material choice because it’s isotropic—its properties are uniform in all directions. Cast steel points absorb impact and transfer it uniformly to the end of the pile.
Tips are pre-beveled, eliminating pile end preparation. The weld prep is already built into the point; our castings have a 45 degree weld chamfer so there is no need to chamfer piles.
Welding Procedures
- To insure proper seating of the tip, remove all flash from end of pile and insert tip.
- Using a 70xx series rod, make a single pass weld (see table) across each flange on the outside only.
- Do not weld web or inside of flanges.
- For heavier sections, you may want to use multiple welding passes.